سلام در انتخاب پاسخ این سوالات کمکم کنید
Consider an Ethernet crossover cable between two 10/100 ports on Cisco switches.
One switch has been configured for 100-Mbps full duplex. Which of the following is
true about the other switch?
a. It will use a speed of 10 Mbps.
b. It will use a speed of 100 Mbps.
c. It will use a duplex setting of half duplex.
d. It will use a duplex setting of full duplex
گفته bوc.گزنیه bدزسته اما نمیدونم چراcدرسته؟؟باید dباشه
**********
Which of the following configuration issues will keep a SPAN session from becoming active?
a. Misconfigured destination port
b. Destination port configured as a trunk
c. Destination port shutdown
d. Source port configured as a trunk
کلا نمیدونم چرا گزینه c را چرا انتخاب کرده؟
*********
Which of the following are rules for SPAN configuration?
a. SPAN source and destination ports must be configured for the same speed and
duplex.
b. If the SPAN source port is configured for 100 Mbps, the destination port must
be configured for 100 Mbps or more.
c. In a SPAN session, sources must consist of either physical interfaces or VLANs,
but not a mix of these.
d. Remote SPAN VLANs must be in the range of VLAN 1–66.
e. Only three SPAN sessions can be configured on one switch
گفته c.اما چرا در خود spanگزینه های a,bدرست نیست ؟ طبق کتابccie vol -1صفحه25 گکزینه های aوbرا گفته ؟؟؟

ممنون میشم کمکم کنید